Installation Safety

• Check the information in the manual and installation instructions to prepare the product for installation and make sure the electrical mains, clean water mains and water outlet are suitable. If not, call a qualified electrician and plumber to have them make the necessary arrangements. These operations are the responsibility of the customer.
• Prior to commencing the installation, be sure to switch off the fuse to deactivate the power supply for the line to which the product will be connected.
• This product is intended for use at altitudes not exceeding 2000 meters above sea level.
• Check the product for any damage before installing it.
• Always wear personal protective equipment (gloves, etc.) during product installation, maintenance and repair. There is a risk of injury.
• Injuries may occur if hands are put into uncovered slots. Close the holes of the transportation safety bolts with plastic plugs.
• Do not install or leave the appliance in areas exposed to environmental conditions like rain or sunlight.
• Do not install the product at locations where the temperature drops below 0 ºC.
• Do not place the product on a carpet or similar surface. It would create fire hazard since it cannot receive air from underneath.
• Place the product on a level and hard surface and balance with the adjustable feet.
• Connect the product to a grounding plug protected by a fuse suitable to the current values on the type label. Make sure the grounding is carried out by an expert electrician. As required by local and national regulations, do not use the product without proper grounding.
• Plug the product in a socket with voltage and frequency values suitable to those indicated on the type label.
• Do not plug the product into loose, broken, dirty, greasy, or water-damaged sockets.
• Use the new hose set provided with the product. Do not re-use old hose sets. Do not extend the hoses.
• Connect the water inlet hose directly to the water tap. The pressure from the tap should be minimum 0.1 MPa (1 bar) and maximum 1MPa (10 bars). 10 to 80 litres of water should be running from the tap in a minute in order for the product to function properly. If the water pressure is above 1 MPa (10 bars), a pressure-reducing valve should be fitted. The maximum allowed temperature is 25°C.

• Fit the end of the water discharge hose to the wastewater drain, the sink or the bathtub.
• Place the power cable and hoses in locations without risk of tripping.
• Do not install the product behind a door, a sliding door or at another location that will prevent the door from opening completely.
• If a dryer is to be placed on the product, fix with a suitable connection apparatus obtained from the authorised service.
• There is a risk of contact with electrical components when the upper tray is removed. Do not dismantle the upper tray of the product.
• Keep the appliance at least 1 cm from furniture.