Antenna Settings for Digital Satellite Channels and Searching for Channels Automatically with the Single Channel Router (SCR) system
NOTICE

Your TV supports SCR (Single Channel Router) system. SCR (Single Channel Router - EN 50494).
LNB settings described in the following section require significant expertise on satellite systems. Contact an expert about the subject.
- Press the
to switch to the TV mode.
- Press the
, select Source and press the
.
- Select Satellite option, and press the
.
- Press the
, select Settings and press the
.
- Select Channels & Inputs option, and press
.
- Select Channels option, and press the
.
- Channel menu will be displayed.
- Select Channel Installation Mode option, and press the
.
- Select Satellite (Standard) or Satellite (Operator Mode) if you are using an operator, and press the
.
- Select Channels option, and press the
.
- Select Automatic Channel Scan option, and press the
.
- Automatic Channel Scan menu will be displayed.
- Select Other option, and press
.
- As per the type of the single cable router multiswitch on your antenna system, select Single Cable I or Single Cable II and press the
.
- Single Cable I: By using a single channel router, a maximum of 8 different devices can be broadcast with the same cable.
- Single Cable II: By using a single channel router, a maximum of 32 different devices can be broadcast with the same cable.
- Depending on your selection of Single Cable I or Single Cable II 8 or 32 user bands will be displayed in the Tuner menu.
Note:
- Example setup is explained for eight devices with Single Cable I.
- Select the required options with the .
- Tuner: Select between User band 1 and User band 8 and confirm with.
- Band Frequency: Select the band frequency with and confirm with
.
- User Defined: You can set the band frequency yourself. From the Band Frequency field, select User Defined. User Defined option will be displayed in the Single Cable I menu. Enter user defined frequency with the .
- Select Next option and press the
.
- Automatic Channel Scan menu will be displayed.
- Select the first satellite displayed in the menu and press the
.
- Select Satellite Status as On.
- Select Satellite Selection using the
and select the satellite you wish to use for searching.
- Select Scan Mode and select between All and Network.
- Select Scan Type.
- Select Only Free Channels for unencrypted channels only
- Select Encrypted Channels Only for encrypted channels only
- Select All for all satellite channels.
- Select Store Type.
- Select Only Digital Channels for TV channels only
- Select Only Radio Channels for radio channels only
- Select All for scanning both options.
- Select LNB Settings and press the
.
- Select Location option, and press the
- Select the location corresponding to the satellite you want to search and press the
.
- Return to the Automatic Channel Scan menu by pressing the
twice.
Note:
- Make the settings described in steps 15 to 26 for each satellite you want to scan.
- Select Next option and press the
.
- Automatic Search menu will be displayed and the search for TV stations shall start.
- Search may take several minutes depending on the number of television stations received.
Notes:
- Use installation equipment supported / suggested by the SCR router.
- Other users / receivers connected to the system may be affected if the specified user band number and frequency are changed during installation.
- User band and User band frequency are specified on the SCR router used; and each user / receiver must select a specified user band and user band frequency.
- With SCR satellite system, auto search by several users / receivers at the same time may cause problems.
- Press
to return to the previous menu, press
to return to TV broadcast or press
to return to Home menu.