Antenna Settings for Digital Satellite Channels and Searching for Channels Automatically with DiSEqC 1.0/1.1
NOTICE

LNB settings described in the following section require significant expertise on satellite systems. Contact an expert about the subject.
- Press the
to switch to the TV mode.
- Press the
select Source and press the
.
- Select Satellite and press the
.
- Press the
, select Settings and press the
.
- Select Channels & Inputs option, and press
.
- Select Channels option, and press the
.
- Channel menu will be displayed.
- Select Satellite and press the
.
- Select Channel Installation Mode option, and press the
.
- Select Satellite (Standard) if you are using an operator, and press the. Satellite (Operator Mode) and press the
.
- Press the
to return to the previous menu.
- Select Channels option, and press the
.
- Select Automatic Channel Scan option, and press the
.
- Automatic Channel Scan menu will be displayed.
- Select Other option, and press
.
- As per your current antenna type, select DiSEqC 1.0 or DiSEqC 1.1 and press the
.
- DiSEqC 1.0: By using a satellite or switch, broadcasts can be received from up to four different satellites at the same time.
- DiSEqC 1.1: By using a satellite or switch, broadcasts can be received from up to sixteen different satellites at the same time.
- Depending on your selection of DiSEqC 1.0 or DiSEqC 1.1, 4 or 16 satellites will be displayed in the menu.
Note:
- Example setup is explained with 4 satellites as per DiSEqC 1.0.
- Select a satellite from the Automatic Channel Scan menu and press the
.
- Select the required options with the .
- Satellite Status: Select On.
- Satellite Selection: Press
, select the satellite you want to search for and press the
.
- Scan Mode: Select Full or Network.
- Scan Type: Select for unencrypted channels only Only Free Channels, encrypted channels only Encrypted Channels Only or for all satellite channels All.
- Channel Store Type: Select for TV channels only Only Digital Channels, for Radio channels only Only Radio Channels or for all channels All.
- Select LNB Settings and press the
.
- Select the required options with the .
- LNB Power: Press
and select LNB power On then press
.
- LNB Frequency: Press
and select LNB frequency used in the satellite system and press again the
.
- DiSEqC Port: Press
.
- DiSEqC Port menu will be displayed.
- To select the satellite corresponding to the relevant DiSEqC positions in the satellite system, select DiSEqC A, DiSEqC B, DiSEqC C or DiSEqC D.
Note:
- If Antenna Type, DiSEqC 1.1 is selected, make a selection between Uncommit 1 and Uncommit 16.
- Return to the Automatic Channel Scan menu by pressing the
twice.
Note:
- Make the settings described in steps 16 to 20 for other three satellites you want to scan.
- After completing the settings individually for all four satellites, from the Automatic Channel Scan menu Next and press
.
- Automatic Search menu will be displayed and the search for TV stations shall start.
- Search may take several minutes depending on the number of television stations received.
- Press
to return to the previous menu, press
to return to TV broadcast or press
to return to Home menu.