Antenna Settings for Digital Satellite Channels and Searching for Channels Automatically with the Single Channel Router (SCR) system

NOTICE

Your TV supports SCR (Single Channel Router) system. SCR (Single Channel Router - EN 50494).

LNB settings described in the following section require significant expertise on satellite systems. Contact an expert about the subject.

Press the

to switch to the TV mode.

Press the

, select Source and press the

Select Satellite option, and press the

Press the

, select Settings and press the

Select Channel option, and press the

Channel menu shall be displayed.

Select Channel Installation Mode option, and press the

Select Satellite (Standard) or Satellite (Operator Mode)if you are using an operator, and press the

Select Channels option, and press the

Select Automatic Channel Scan option, and press the

A warning message will be displayed.

Channels in the previous channel search will be deleted and the channel search will be performed again. Select Next and press the

to continue.

Automatic Channel Scan menu shall be displayed.

Select Antenna Type option and press the

Antenna Type menu shall be displayed.

As per the type of the single cable router multiswitch on your antenna system, select Single Cable I or Single Cable II and press the

Single Cable I: By using a single channel router, a maximum of 8 different devices can be broadcast with the same cable.
Single Cable II: By using a single channel router, a maximum of 32 different devices can be broadcast with the same cable.

Depending on your selection of Single Cable I or Single Cable II 8 or 32 user bands shall be displayed in the Tuner menu.

Note:

Example setup is explained for eight devices with Single Cable I.

Select the required options with the .

Tuner: Select between User band 1 and User band 8 and confirm with .
Band Frequency: Select the band frequency with and confirm with .
User Defined: Youcan set the band frequency yourself. From the Band Frequency field, select User Defined. User Defined option shall be displayed in the Single Cable I menu. Enter user defined frequency with the .

Select Next option and press the

Automatic Channel Scan menu shall be displayed.

Select the first satellite displayed in the menu and press the

Select Satellite Status as On.

Select Satellite Selection using the

and select the satellite you wish to use for searching.

Select Scan Mode and select between All and Network.

Select Scan Type.

Select Only Free Channels for unencrypted channels only
Select Encrypted Channels Only for encrypted channels only
Select All for all satellite channels.

Select Store Type.

Select Only Digital Channels for TV channels only
Select Only Radio Channels for radio channels only
Select All for scanning both options.

Select LNB Settings and press the

Select Location option, and press the

Select the location corresponding to the satellite you want to search and press the .

Return to the Automatic Channel Scan menu by pressing the

twice.

Note:

Make the settings described in steps 14 to 24 for each satellite you want to scan.

Select Next option and press the

Automatic Search menu shall be displayed and the search for TV stations shall start.
Search may take several minutes depending on the number of television stations received.

Notes:

Use installation equipment supported / suggested by the SCR router.
Other users / receivers connected to the system may be affected if the specified user band number and frequency are changed during installation.
User band and User band frequency are specified on the SCR router used; and each user / receiver must select a specified user band and user band frequency.
With SCR satellite system, auto search by several users / receivers at the same time may cause problems.

Press

to return to the previous menu, press

to return to TV broadcast or press

to return to Home menu.