Antenna Settings for Digital Satellite Channels and Searching for Channels Automatically with DiSEqC 1.0/1.1

NOTICE

LNB settings described in the following section require significant expertise on satellite systems. Contact an expert about the subject.

Press the

to switch to the TV mode.

Press the

, select Source and press the

Select Satellite and press the

Press the

, Select Settings and press the

Select Channel option, and press the

Select Channel Installation Mode option, and press the

Select Satellite (Standard) or Satellite (Operator Mode)if you are using an operator, and press the

Select Channels option, and press the

Select Automatic Channel Scan and press the

Channels in the previous channel search will be deleted and the channel search will be performed again. Select Next and press the

to continue.

Select Antenna Type option and press the

As per your current antenna type, select DiSEqC 1.0 or DiSEqC 1.1 and press the

DiSEqC 1.0: By using a satellite or switch, broadcasts can be received from up to four different satellites at the same time.
DiSEqC 1.1: By using a satellite or switch, broadcasts can be received from up to sixteen different satellites at the same time.

Depending on your selection of DiSEqC 1.0 or DiSEqC 1.1, 4 or 16 satellites shall be displayed in the menu.

Select a satellite from the Automatic Channel Scan menu and press the

Select the required elements with the .

Satellite Status: Select On.
Satellite Selection: Press , select the satellite you want to scan and confirm with .
Scan Mode : Select Full or Network.
Scan Type: Select Only Free Channels for free channels only, Encrypted Channels Only for encrypted channels or All for all satellite channels.
Store Type: Select Only Digital Channels for television channels only, Only Radio Channels for radio channels or All for searching both.

Select LNB Settings and press the

Select the required elements with the .

DiSEqC Port: Press

To select the satellite corresponding to the relevant DiSEqC positions in the satellite system, select DiSEqC A, DiSEqC B, DiSEqC C or DiSEqC D.

If Antenna Type, DiSEqC 1.1 is selected, make a selection between Uncommit 1 and Uncommit 16.

Return to the Automatic Channel Scan menu by pressing the

twice.

Make the settings described in steps 11 to 19 for other three satellites you want to scan.

After completing the settings individually for all four satellites, from the Automatic Channel Scan menu, select Next and press the

Automatic Search menu shall be displayed and the search for TV stations shall start.
Search may take several minutes depending on the number of television stations received.

Press

to return to the previous menu, press

to return to TV broadcast or press

to return to Home menu.